How To

GE Refrigerator Water Tastes Like Plastic [Solution]

If you are wondering why your GE refrigerator water tastes like plastic, this article tells you why and how to fix it.

GE Refrigerator Water Tastes Like Plastic

GE Refrigerator Water Tastes Like Plastic – Quick Fix

Here are ways to fix the problem of a GE refrigerator water that tastes like plastic:

Purge the Dispensing System

Run the dispensing system for a few minutes. Keep running the tap until you have filled at least 2 to 3 gallons.

To make it easier, connect a pipe to the faucet and lead it to a bucket. With this, you may not have to worry about an overfill problem.

This should take care of it. However, if the taste persists, change the water supply tube.

Change the Water Supply Tube

To change the water supply tube, disconnect the appliance from the power source and pull it away from the wall. The tube connects the water supply to the refrigerator. Replace it with either a copper or polypropylene tube. This is true if the connection was done with a braided plastic tube.

Afterwards, flush the dispensing system by dispensing at least two gallons of water. It should do the trick. You should, also, consider dumping the ice from the ice maker because it may have a similar taste.

Replace the Water Filter

To install a new water filter, open your refrigerator and look into the upper left corner of the refrigerating section. Then, place a towel under the filter housing before opening the door to absorb any water that may drip.

Next, turn the old filter to the right until it is almost at a 90-degree angle. Pull it out but do not twist the cartridge. Note that the filter may not come off if it is not aligned at almost a 90-degree angle.

Now, align the top of the new filter, with the word “Front” facing outward. Push the filter in to ensure it is properly seated. Once more, be careful not to twist the cartridge. Then, slide the filter back into position, and shut the door.

GE RPWFE Refrigerator Water Filter

Buy this water filter on Amazon

 

 

 

 

Other Filters

If your filter is located inside the refrigerator door, here is how to change it:

Open the filter housing door, gently raise the filter upwards until it stops, then pull it down without twisting.

Next, take the new filter and firmly insert it until it locks into position. Then, slide the filter back into position without twisting it.

Afterwards, flush the system with at least 2 gallons of water. This is because you need to purge the filter of ant air in it.

Watch this video to learn more ways to fix this problem…

If you follow these steps yet the plastic taste remains, then it could be from the water supply. So, ensure this is not the case before trying to carry out the other repairs.

It is important to note here that it is normal for the first water and ice from a new refrigerator to taste like plastic. This makes it non-consumable.

So, once you buy a new refrigerator, flush the system with at least 2 to 3 gallons of water. Afterwards, the water should be good for consumption.

Furthermore, a water filter has carbon in it that wears off after a little while. So, ideally, replace the filter once every six months.

Recap

The plastic taste on your GE refrigerator water could be coming from the plastic components within the system. The problem could also be from either the water supply, the water tube, or the water filter.

If you are still unsure of the source of the plastic taste problem, contact GE care for further assistance. Alternatively, chat with any of our technicians to assist you.

Check out these other articles…

GE Refrigerator Making Ice – Issues [Solved]

GE Refrigerator Ice Maker Water Overflow [How to Fix]

GE Ice Maker Does Not Fill with Water [How to Fix]

Water Under GE Refrigerator [How to Fix]

GE Refrigerator Does Not Stop Running [How to Fix]

Water in Bottom of GE Refrigerator [Quick Fix]

GE Refrigerator and Freezer Not Getting Cold [How to Fix]