Many issues can develop with refrigerator doors, including a Frigidaire refrigerator door. So if you are looking for solutions to such issues, you have come to the right place.
Table of Contents
Frigidaire Refrigerator Door Alarm Keeps Beeping – How to Fix
If you are sure it is the door alarm that is beeping, make sure it is closed and seals properly. If it is even slightly open, the door alarm will keep beeping until you close it fully.
Check the contents of the refrigerator and rearrange them if any is sticking out. Ensure the door seal is working well and is not dirty. Replace the seal if it is not sealing well and clean it with warm water and soap if it is dirty.
Additionally, be sure the refrigerator is level. Improper leveling keeps the door from closing fully. Check the leveling screws or legs at the back and adjust them if necessary.
If you fix all of the above and the alarm is still beeping, then press the alarm reset button just once. If your refrigerator model does not have this button, check to see if there is a button marked ‘Set’. Press it if there is.
However, if none of the above fixes the alarm, reset the refrigerator. Disconnect it from electric power, wait about ten minutes, and reconnect it. This is a hard reset and may fix it.
Hire a repair technician to check the control board or the buttons if the hard reset does not fix the alarm.
Frigidaire Refrigerator Door Clicking Noise – Quick Fix
There is a tiny notched ring made of plastic that wraps around the door’s hinge pin. This ring is called a closing cam or a bearing, and it helps the door to close properly so it is always working.
But if you start hearing a clicking or popping noise from the door, the cam may be cracked or have a damaged notch. You will have to replace it.
To replace the ring or cam, take the following steps:
Step One
Turn off the temperature controls of both compartments of the refrigerator. If your model does not have two compartments, just turn off that of the refrigerator. Then, disconnect the unit from electric power.
After the disconnection, remove every item that is stored in the door of the unit. Put them inside the refrigerator or in another unit. And if there is any bin that is detachable, remove it, too.
Step Two
Close the door and check the top, where the hinge usually is. You will find a cover over the hinge with a screw holding it in place. Unthread the screw and remove the hinge cover.
Step Three
Get a socket wrench and fix a ⅜ inch socket to it. Use the wrench with the socket to remove the two bolts holding the door hinge in place. Afterward, remove the hinge and set it aside.
Next, grab both sides of the door, swing it to open it about six inches, and lift it off the hinge at the bottom. Set the door down on a flat and stable surface.
Step Four
Locate the plastic cam along the door’s bottom. You should find it around the door’s hinge pin. Using a small screwdriver with a flat blade, pry the cam off the door.
Insert the new ring or closing cam into the position of the former one. Make sure to push the door hinge up to rest against the door.
Replace the door, retracing your steps accurately as you do. Then, reconnect the refrigerator to electric power.
Frigidaire Refrigerator Door Not Closing Properly – Solutions
There are a few steps to take in order to fix the issue of the refrigerator door not closing properly:
1. Adjust Bins and Shelves
Storing food in the refrigerator tends to make some of the shelves and bins move out of position. This is not readily noticeable until you want to close the door.
Therefore, inspect each drawer, bin, and shelf to be sure it is in place and not sticking out. To be sure, push each one in until it hits the back of the unit.
2. Rearrange Items
Food and other items in the refrigerator could also stick out, especially when you overstuff the unit. The door won’t close properly if there is an item protruding from the shelf.
Check every item and rearrange them if you have to. If you put too much in the refrigerator, reduce the number of items so the door can shut properly. Not only does this help the door but it also helps the circulation of cold air.
3. Inspect the Door Seal
Check the seal around the door for dirt or looseness. If it is noticeably dirty, clean it thoroughly using warm water and soap. Believe it or not, dirt keeps the seal from working as it should.
But if it is loose, push it in with a small screwdriver without puncturing it. You can also rub petroleum jelly on any part of it that is folded in or bent out of shape.
4. Check the Door Alignment
If you recently removed the door to move the refrigerator or just installed the unit, check to see whether or not the door aligns with the body. You will find the door not closing fully if it is out of alignment.
For proper alignment, consult the user manual for the refrigerator. How you align will depend on the refrigerator model you own. But if you don’t have that anymore, contact Frigidaire or a qualified repair technician for assistance.
5. Level the Unit
The door won’t close properly or even stay closed if the unit is not level. Set a level on the refrigerator’s top and check the middle window bubble. If the bubble keeps moving without staying centered, level the unit.
Lift the left and right clips on the sides of the toe grille, open the door, and press the top of the grille firmly until it releases. Pull out the grille’s base until it loosens and the grille comes out.
Close the door and adjust the feet using a flat-blade screwdriver. If the hinge of your model has a set screw, remove it before making any adjustment.
Turn the screws clockwise to adjust them and raise the feet. If you need to lower them, go counterclockwise. Just make sure the bubble centers before you stop. The door should close automatically when opened at a 90-degree angle if the leveling is done right.
Check out these other articles…
Frigidaire Refrigerator Keeps Running [How to Fix]
Frigidaire Fridge Keeps Turning Off [Quick Fix]
Frigidaire Refrigerator Has Low Water Pressure [How to Fix]
Frigidaire Refrigerator Making Noise [How to Fix]
Frigidaire Refrigerator Problems [Quick Solutions]
Frigidaire Refrigerator Beeping with Door Closed – Solved
The door gasket may be loose or worn out, causing poor sealing. The refrigerator is reading that the door is not shut properly and the temperature is rising. Therefore, it is beeping to alert you.
Replace the seal if it is worn out. Push it into place if it is only loose. Clean it if it is significantly dirty. Then, check for proper suction when you shut the door.
If the alarm keeps beeping after this, the temperature may be high. The refrigerator will need about 2 hours to cool to a food-safe level. But you can shut off the alarm by pressing the alarm reset button.
However, if the reset does not work, and nothing is keeping the door open, the problem may be from the control board.
Frigidaire Refrigerator Door Ice Dispenser Not Working – How to Fix
Do the following if the ice dispenser on your Frigidaire refrigerator door is not working:
- Test the dispenser switch
2. Check the auger motor
3. Troubleshoot the dispenser control board
4. Test the dispenser actuator
5. Check the ice bucket auger
6. Test the dispenser solenoid
This article discusses more on how to fix each component easily.
Frigidaire Refrigerator Door Water Dispenser Leaking – Quick Fix
Check the following for faults if the water dispenser on a Frigidaire refrigerator door is leaking:
- Vinyl tubing
2. Water supply line
Replace the faulty one and read this article for steps to take to fix them.
Frigidaire Refrigerator French Door Ice Maker Not Working – How to Fix
The following are possible reasons why the ice maker on the door of your Frigidaire french-door refrigerator is not working:
- High freezer temperature
2. Old water filter
3. Turned-off ice maker
4. Weak door seal
5. Faulty water inlet valve
6. Defective door switch
7. Bad ice maker assembly
There are details on how to fix these problems in this article. Read to learn more.
This video shows how to replace the ice maker in a Frigidaire french-door refrigerator…
Frigidaire Refrigerator Door Handle Is Loose – Quick Fix
You will find an Allen slot on the inside part of the handle of the door, at the top. Take an Allen wrench and insert it into this slot. Next, turn it clockwise to tighten it. Do the same for the bottom inside part of the handle.
Follow the steps in this video to fix a loose Frigidaire refrigerator door handle…
Frigidaire Refrigerator Water in Door Not Working – Solutions
The following are possible solutions to a Frigidaire refrigerator water in the door not working:
- Thaw a frozen water tube
2. Replace a defective water inlet valve
3. Change the water filter
4. Test the dispenser switch
5. Troubleshoot the dispenser control board
6. Test the door switch
To know how to accurately solve the problems, read this article that explains the steps.
Frigidaire Refrigerator Door Leaking Water – Solved
If the refrigerator has a water dispenser in the door, check the vinyl tubing and the water supply line of the water dispenser.
You can also check the water filter, water line for kinks or trapped air, and water pressure.
But if it does not, there may be a food item in the door that is dripping water. If there is, put the item into a container or into a vegetable drawer.
Frigidaire Refrigerator Door Panel Not Working – What to Do
Reset the control panel if you find it is not working. This is especially true if there was a recent power outage.
Disconnect the refrigerator from power, wait about 30 seconds, and reconnect it to electric power. Wait about 5 minutes before turning the refrigerator back on.
If this does not work, the problem may be that the panel is locked. Press the control lock key and hold it down for 3 seconds. The panel will turn on.
However, if none of these works, the circuit board may be malfunctioning. Consider replacing it or hiring a qualified technician for more troubleshooting steps.
Frigidaire Refrigerator Door Hard to Open – Quick Fix
Allow some time to pass before trying to open the door if you or someone else just shut it. The air within thins, the colder it gets. This creates suction to help the door to seal properly. The vacuum needs some minutes to be released before you can open the door again. This is absolutely normal.
However, if this is not the case and the door is always hard for you to open, apply petroleum jelly on the door seal. Paraffin wax also works and is food-safe. Either of these lubricants keeps the door seal from sticking too hard.
Another factor is to check whether or not there is a sugary drink spillage around the door frame. The seal can stick to the sugary drink and stick. Other foods can also cause the door to stick.
Clean the seal and door frame. And make sure water does not pool around the frame. Otherwise, it may freeze the door shut.
Frigidaire Refrigerator Door Won’t Stay Open – Solutions
Consider doing any of the following to fix this problem:
- Adjust the levers at the back
2. Level the refrigerator from side to side
3. Adjust or align the door
Note: The door may be made to close automatically. It helps to reduce the escape of cold air and the entrance of warm air, especially if the door is usually held open for extended periods.
Frigidaire Refrigerator Rolls When Door Opens – Quick Fix
Adjust the leveling feet or legs of the refrigerator. It is not supposed to move or roll whenever you open the door.
Consult your user manual or contact Frigidaire for instructions on how to level the feet of the refrigerator properly.
Get Instant Help — Ask An Experienced Verified Appliance Technician
Need expert help? Click here to use the chat box on this page to speak with a verified appliance technician right away. No need for expensive in-home service calls. No appointments. No waiting.