The case of a leaking refrigerator is not uncommon. In fact, it is so common that most of the reasons for it are not farfetched. And at such, some of them can be resolved even without the help of a service technician. Hence, this article discusses how to solve the problem of a Daewoo refrigerator leaking.
Table of Contents
Daewoo Refrigerator Leaking Water – What to Check
This section discusses the parts to check if your Daewoo refrigerator is leaking water. How to troubleshoot and resolve each of these problem parts is the focus of this section. If at any point the repair gets too complex, stop work and contact a repair technician.
1. Drainage Tube
The drainage tube can get clogged with ice, food particles, or other debris. When this happens, water will overrun the tube and spill out of the refrigerator. This is the most common reason for a leaking refrigerator and so should be the first stop.
To resolve this issue, the drainage tube has to be unclogged. The tube is located behind the refrigerator so take off the back access panel. Locate the tube and use a hairdryer to heat it and thaw the ice. Or you may simply defrost the refrigerator, read this article for how to do this in minutes.
If that does not solve the problem, then open the refrigerator and locate the tube’s entrance hole. Insert a plumbing snake into the hole and pull out the clog. Afterward, make a mixture of warm water and baking soda and flush it down the tube.
You will know the tube is clean if you hear water flowing into the drain pan below. This should solve the issue if a clogged drainage tube was the cause of the leak.
2. Door Gasket
The door gasket should be your next stop if the water is dripping from the door of your unit. The gasket is responsible for keeping moisture out of the refrigerator. However, the gasket can get worn-out and become unable to seal off properly.
When this happens, the moisture that enters the refrigerator may then spill down the refrigerator’s door. Inspect the door gasket and replace it if it is broken or worn-out.
How to Replace Daewoo Refrigerator Door Gasket
Do the following to replace the leaking door gasket of your Daewoo refrigerator:
Step 1: Open the refrigerator door and use a putty knife or a flat-head screwdriver to pry off the top corner of the door gasket.
Step 2: Pull off the already removed top corner to remove the gasket completely. Check the track and ensure there is no debris or remnant of the gasket on it.
Step 3: Place the new gasket on the track, ensure the gasket is compatible with your refrigerator. Pin the little plastic dot on each corner of the gasket to the refrigerator’s track.
Step 4: Work your way around the gasket and clip it firmly to the track. Double-check your work and ensure the gasket does not have any bumps or folds.
3. Water Filter
If the water filter is inside the refrigerator then it may be the reason your Daewoo refrigerator is leaking water inside. Remove the filter and inspect the head for damage, like a broken or missing seal. If the filter head is damaged, then replace the filter to solve the problem.
Also, the filter may be leaking if it is old. When the filter gets old, it begins to clog, and cleaning it will not solve the problem. Therefore, the filter should be replaced. Ensure to replace the filter as often as recommended.
If the filter is not damaged or old then it may have been installed incorrectly. Simply take out the filter and reinstall it to solve the problem. You may check your user’s manual for how to properly install your water filter.
4. Water Filter Housing
The water filter housing may be the cause of the leak if it has a crack. Take out the water filter and inspect the filter housing for cracks. Replace the housing if is cracked.
How to Replace Daewoo Refrigerator Water Filter Housing
To replace the water filter housing of your Daewoo refrigerator, do the following:
Step 1: For safety, unplug the refrigerator and turn off the water supply. Next, take out the water filter by turning it counterclockwise.
Step 2: Unthread the screw holding the water filter housing in place and pull the housing forward.
Step 3: Shift the refrigerator from the wall so you will have access to the back of the appliance. And, remove the water line from the back of the refrigerator. Next, unthread the screws holding the back access panel in place and then take off the panel.
Step 4: Remove the water lines from the valve using an open-end wrench.
Step 5: Go back to the front of the appliance and gently pull out the filter housing. Disconnect the water line from the old housing and attach it to the new filter housing.
Step 6: Install the new filter housing and recouple the refrigerator by doing the steps in reverse order.
5. Water Inlet Valve
The water inlet valve opens and closes to supply water to the refrigerator. The valve may refuse to shut off properly if the valve is defective or the water pressure is too low.
Check the water pressure with a water pressure regulator, the pressure should be a minimum of 20 psi. If the pressure is below this, then the water line or the water source is the cause of the problem.
Replace the water line and if that doesn’t solve the problem, then change the water source. If the valve keeps leaking water then it is defective and should be replaced.
If you do not have enough technical skills do not attempt to carry out this repair by yourself.
How to Replace Water Inlet Valve of a Daewoo Refrigerator
The steps below will guide you on how to replace the water inlet valve of a Daewoo refrigerator:
Step 1: Unplug the refrigerator to avoid electrocution and shut off the water supply.
Step 2: Turn the refrigerator from the wall to have full access to the back of the appliance. Next, remove the water line off the back panel by releasing the tabs holding them in place.
Step 3: Unthread the screws holding the back access panel and take it off. Next, locate the inlet valve and disconnect the first water line.
Step 4: To disconnect the remaining water line, the inlet valve has to be unmounted. So, unthread the screws holding the inlet valve and then take it out.
Step 5: Now, disconnect the water lines and wire harness connected to the valve. The valve should be completely free at this point.
Step 6: Connect the water lines to the new inlet valve. Put it in place and screw the valve back in place. Attach the last water line and screw the access panel back on.
Step 7: Turn on the water supply and the refrigerator and then access the valve to ensure it is properly fitted. If it is, replace the back access panel and then adjust the refrigerator to its original position.
6. Water Reservoir Assembly
The water reservoir may be cracked if the Daewoo refrigerator is leaking water inside. Inspect the reservoir for any crack. The reservoir is made of plastic and so it cannot be repaired. Therefore, the reservoir has to be replaced to solve this problem. We recommend that you contact a service technician for this repair.
7. Drain Tray
The drain tray collects the water that melts off during the defrost process. If the tray becomes cracked, then it will cause water to leak underneath your Daewoo refrigerator.
The drain tray is located at the rear bottom of the refrigerator. Take off the access panel and then remove the drain tray. Inspect it for cracks and replace the tray if any is found.
Check out these other articles…
Beko Refrigerator Leaking [Solved]
Hotpoint Refrigerator Leaking [How to Fix]
Miele Refrigerator Leaking [Solved]
Thermador Refrigerator Leaking [How to Fix]
RCA Refrigerator Leaking [Quick Fix]
Daewoo Fridge Water Dispenser Leaking – Why and Resolution
The following are the common reasons your Daewoo fridge water dispenser is leaking and how to solve them
1. The Refrigerator is not Leveled
Water may drip out of the water dispenser drip tray if the refrigerator is not properly leveled. Therefore, use a level to check the refrigerator. If it is not leveled then do the following to resolve it:
Step 1: Remove the screw holding the grille at the bottom of the refrigerator and take it out. If your model does not have a grille, skip this step.
Step 2: The leveling legs will be visible with the grille removed. Turn the leveling legs clockwise to raise them and counterclockwise to lower them.
Step 3: If reaching the legs is hard, then you may ask someone to help tilt the refrigerator a bit backward. And then adjust the legs to level the refrigerator.
Step 4: Finally, use the level to confirm that the refrigerator is properly leveled. And then put the grille back on.
Watch this video for a visual representation of how to level your Daewoo refrigerator
2. Dispenser Tray is Full
The dispenser drip tray collects the water that drips out of the dispenser before it shuts off completely. The tray can get too full and will result in a continuous drip. The solution to this is to remove the drip tray, empty it and reinstall it back.
3. Loose Water Connection
Check the water connections to the water dispenser. It may be the cause of the leak if it is too loose or not properly fitted. Tighten the water lines if it appears to be the problem.
4. Air is Stuck in Water System
Air sometimes gets stuck in the water system after a filter change. This often results in a pressure build-up that will cause the water lines to overflow and leak.
Luckily, this problem can be rectified by dispensing about 10 liters of water. Ensure the water system is flushed after every filter change so this problem does not reoccur.
Conclusively, if your Daewoo refrigerator keeps leaking water after you try all these solutions, contact a repair technician.
Get Instant Help — Ask An Experienced Verified Appliance Technician
Need expert help? Click here to use the chat box on this page to speak with a verified appliance technician right away. No need for expensive in-home service calls. No appointments. No waiting.
